Reproduction Parts for 1916-1964 Chevrolet Passenger Cars & 1918-1987 Chevrolet & GMC Trucks



Visit the new site at vcca.org

Previous Thread
Next Thread
Print Thread
Rate Thread
Joined: Oct 2007
Posts: 304
Backyard Mechanic
OP Offline
Backyard Mechanic
Joined: Oct 2007
Posts: 304
I purchased a delco remy contact set D-100H 1882965 from the Filling Station for my 36 Standard. My question is how do I install it so the stationary point on the spring steel connector does not slide up the shaft? The points I have installed in the past came with both parts attached and installed togeather. Top section fits loosly and as soon as I try to start the engine it rides up.

Joined: Sep 2007
Posts: 654
Likes: 3
Oil Can Mechanic
Offline
Oil Can Mechanic
Joined: Sep 2007
Posts: 654
Likes: 3
Make sure the screw that holds it is drawn down fully and tight. Is the spring twisted?

Last edited by J Franklin; 07/22/23 12:56 AM.

J Franklin
Joined: Oct 2007
Posts: 304
Backyard Mechanic
OP Offline
Backyard Mechanic
Joined: Oct 2007
Posts: 304
I thought I had it as tight as it should go. The spring is straight. I'll give it another try ThanksS

Joined: Sep 2007
Posts: 654
Likes: 3
Oil Can Mechanic
Offline
Oil Can Mechanic
Joined: Sep 2007
Posts: 654
Likes: 3
The notch in the spring needs to be fully down on the post coming into the distributor. Other than that I have no ideas. I've only seen the type of contact set you are describing for my car, a '36 Stadard

Last edited by J Franklin; 07/23/23 02:06 AM.

J Franklin
Joined: Oct 2007
Posts: 304
Backyard Mechanic
OP Offline
Backyard Mechanic
Joined: Oct 2007
Posts: 304
That's what I have..I will take another look at it, I'm sure I'm missing something. Thank you sir.


Link Copied to Clipboard
 

Notice: Any comments posted herein do not necessarily reflect the official position of the VCCA.

Powered by UBB.threads™ PHP Forum Software 7.7.5